Tel: +86-571-86278356
  Request a quote

Home > News > Content
News

G80 Chain Routine Maintenance


G80 chain using high-quality low-carbon alloy steel by heat treatment to ensure that the product's impact resistance, load capacity, toughness and elongation, greatly improving its safety and service life.

G80 chain after a period of time, the need for lubrication of the chain, as a professional plate chain manufacturers, with you today to learn about the G80 chain common lubrication method.

1. Artificial oil or oil brush regularly;

2. drip oil lubrication, with oil cups through the tubing to the inside and outside the loose chain gap between the drop of oil;

3. Oil bath lubrication or splash lubrication, G80 Chain the use of sealed transmission box, the former chain and part of the sprocket immersed in oil, which uses a larger diameter of the oil pan oil splash;

4. Oil pump pressure fuel lubrication, oil pump through the tubing to the chain of continuous oil supply, circulating oil can play the role of lubrication and cooling. G80 Chain The kinematic viscosity of the lubricating oil used in the chain drive is about 20 to 40 mm2 / s at the operating temperature. G80 Chain Only the speed is very slow and can not supply the oil, it can be replaced with grease.

Tips: not only to lubricate, but also daily maintenance.

G80 chain of some knowledge

As the G80 chain with alloy steel material, so when used in the strong wear, but if the operation will still make the G80 chain will be broken, this is called strong cracking, the following small series to do a brief introduction to it.

G80 chain of strong cracking and fatigue cracking is not the same concept, G80 Chain strong cracking refers to the G80 chain has been a strong impact, the chain was forced to pull off, this chain pull off we can avoid, as long as we use the chain when the correct Operation, G80 Chain to ensure that the surrounding environment is no danger, the chain of strong cracking can be effectively avoided.

G80 chain of strong cracking is due to operational errors caused by, we should try to avoid, thus extending the life of the chain. As long as we use the specification, the operation is correct, G80 Chain you can make the G80 chain to play the maximum "power."

Chain for a long time to use, the shape will have some changes, common deformation, distortion, wear and so on, G80 Chain and the chain should be dealt with in a timely manner to reduce the risk of occurrence.

Lifting chain distortion often occurs, for the emergence of the distortion of the operation will have an impact on the operation, the user should do a detailed understanding of the work done.

If the degree of distortion is relatively light, then the user can continue to lift the work, but to do a good job checking the chain, the degree of distortion to do the development of understanding, G80 Chain if you can not rule out the danger should be strictly prohibited.

G80 chain in the use of wear due to failure, which is a very common kind of problem, then the operation can reduce the degree of wear it? In fact, very simple, just two strokes.

The first stroke; in the use of 80 lifting chain before the operation, G80 Chain in its surface evenly coated with a thin layer of lubricating oil, and put it aside for some time, after the grease is fully absorbed, and then use, so you can To achieve the purpose of reducing the degree of wear.

The second measure: According to the actual need to select the appropriate chain of specifications to operate, not only that, if the use of the process, there have been abnormal operation, G80 Chain please stop the operation, the chain maintenance, so you can achieve its wear the goal of.